Other

Custom Cane Creek lower race for Salsa.

Alternator Flat Mount is an adjustable dropout system designed to offer flawless functionality with flat-mount brakes installed. The dropout plates move back and forth on the frame, controlled with a captive barrel nut and screw for a minimal appearance. - Compatible with frames designed for the Alternator Flat Mount standard - Allows the rear axle to be adjusted through a 15mm range - Thru-axle diameter = 12mm; thread pitch = 1.5 - Note: This part number only includes a single Alternator Flat Mount plate - Uses Salsa 465 replaceable derailleur hanger (FS2322), sold separately. Also requires Salsa Axle Stud kit (FS1181) - Hardware kits (sold separately) must always be paired with the style of dropout plates being installed on the frame

Salsa Alternator 1.0 and 2.0 UDH Kit for flat-mount brakes. - This Alternator Plate set works with all Alternator 1.0 and Alternator 2.0 compatible Salsa frames to allow the use of SRAM Full Mount derailleurs or SRAM UDH. - Fixes wheel in rearmost Alternator plate position (17mm back) - Native 140mm flat-mount disc brake compatibility - Includes required upper non-drive side bolt (choose 16mm or 18mm length to match frame thickness) and lock nut. All other hardware is re-used from current plates or can be purchased in the Alternator 1.0 or Alternator 2.0 Hardware Kit. - Requires a 12mm thru axle with 1.0TP and either a SRAM UDH or SRAM Full Mount derailleur (not included). Consult the Plate Kit instructions for recommended axle length based on the frame hub standard. - Engineering Identifier Number: 06-004163

Replacement rear dropout Axle Stud Kit for Carbon V2 Beargrease, Warbird, and Warroad Frames. - Thread diameter and pitch: 12x1.5mm

Replacement derailleur hangers for Salsa frames. - Salsa Derailleur Hanger 1798

Salsa Alternator 1.0 and 2.0 UDH Kit for post-mount brakes. - This Alternator Plate set works with all Alternator 1.0 and Alternator 2.0 compatible Salsa frames to allow the use of SRAM Full Mount derailleurs or SRAM UDH. - Fixes wheel in rearmost Alternator plate position (17mm back) - Native 160mm post-mount disc brake compatibility (no IS adaptor required) - Includes required upper non-drive side bolt (choose 16mm or 18mm length to match frame thickness) and lock nut. All other hardware is re-used from current plates or can be purchased in the Alternator 1.0 or Alternator 2.0 Hardware Kit. - Requires a 12mm thru axle with 1.0TP and either a SRAM UDH or SRAM Full Mount derailleur (not included). Consult the Plate Kit instructions for recommended axle length based on the frame hub standard. - Engineering Identifier Number: 06-004162

Replacement derailleur hangers for Salsa frames.

Salsa Pivot Service Kits